Webasto Thermo 90 Workshop Manual

Thermo 90 1 Introduction
103
• Installation Instructions for Webasto fuel tanks for the
fuel supply of water heaters in vehicles:
In busses the installation is not permit
ted in the
passengers or driver's compartment.
• The fuel filler neck must not be located in the
passen
gers or driver's compartment of any vehicle.
• Fuel containers for carburettor fuel must not be
located imme
diately behind the front panelling of the
vehicle. They must be separate from the engine so
that even in case of an accident the inflammation of
fuel is unlikely to be expected. This does not apply
for towing vehicles with an open cockpit.
All fuel containers offered in the Webasto
Accessories Catalogue are suitable for a maximum
o
perating pressure of 0.15 bar overpressure.
All fuel containers offered in the Webasto
Accessories Catalogue are subjected during
ma
nufacture to individual pressure testing with at least
0.3 bar overpressure.
• The fuel containers must either be equipped with a
ven
t cap or be ventilated in another way (ventilation
line).
Only filler caps in accordance with DIN 73400 may be
us
ed.
• The operational state of the heater, i.e. an indication
"on
" or "off", must be easily and clearly visible.
1.6 Corrections and Improvements
Deficiencies, improvements, or proposals for correction of
this workshop manual are to be mailed to:
Webasto Thermosysteme International GmbH
Abt. Technische Dokumentation
D-82131 Stockdorf
Telefon: 0 89 / 8 57 94 - 5 42
Telefax: 0 89 / 8 57 94 - 7 57

Webasto Thermo 90 Specifications

General

Brand	Webasto
Model	Thermo 90
Category	Water Heater
Language	English