WEAR EYE PROTECTION WHEN SERVICING THIS PRODUCT !
*** SAFE SERVICE ***
DISCONNECT power cord from A.C. power source before initial disassembly of LS200
Light. OBSERVE cautions / warnings in owners manual and printed on the product itself.
COMPLY with all safety codes and practices for this type of product. COMPLY with all
safety regulations at your work place.
PERFORM all recommended Welch Allyn service test procedures to assure the LS200 meets
all requirements safely and reliably.
EXAMINE AND REPAIR OR REPLACE as required, any and all worn or questionable
wiring, components, connections, connectors, warning labels, insulation and other items necessary
for the continued safe operation of this product.
DO NOT TOUCH halogen lamps or nearby parts during or immediately after operation.
WAIT AT LEAST TWENTY MINUTES (20 MIN.) BEFORE TOUCHING HALOGEN LAMPS
OR METAL NEAR THE LAMP(S). VERY HIGH TEMPERATURES will cause severe burns!
Fractured or broken lamps may cause injury. To prevent cuts, REMOVE such lamps by HOLDING
them with a cloth or wear work gloves. WEAR SAFETY GLASSES!
DO NOT LOOK DIRECTLY AT, TOUCH OR SPRAY LIT halogen lamps.
*** QUALITY SERVICE ***
MODIFY your SERVICE Manual by notating changes and revisions of part numbers and
procedures. Enter this information on the appropriate page...and include a copy of the notification
in your Appendix “Product Updates”.
READ AND UNDERSTAND customer comments and complaints on accompanying
documentation (P.O. or other correspondence).
IF AN INJURY OR ILLNESS TO PATIENT OR USER, OR HAZARDOUS MALFUNCTION
HAS OCCURRED OR IS SUSPECTED, DO NOT DISASSEMBLE, REASSEMBLE, ALTER OR
REPAIR THE PRODUCT IN ANY WAY...INSTEAD, GIVE THE UNIT AND ALL
ACCOMPANYING PAPERWORK TO YOUR REPAIR SUPERVISOR. Appropriate action per
approved Welch Allyn policy will be taken.
When performing a complete inspection, LOOK for : missing parts, product defects, damage,
tampering, unsafe condition of wiring or any component. ENTER all findings and test data along
with repair status in the appropriate file.
Most of the repairs can be performed on a foam covered work bench. Place the LS200 in
holding fixture for repairs. Take all actions to prevent scratching the bezel.
4
To Next Page
Loading...
Need help?
General
