Commissioning | 5 | English
Operating instructions UC-Serie | 89014383; Version 2 | 25
5 Commissioning
5.1 Installing the warewasher
The installation site must be frost-resistant to prevent the water supply systems from freezing.
Ø Install the warewasher horizontally using a spirit level.
Ø Adjust any unevenness of the base using the height-adjustable machine feet.
5.2 Connecting the warewasher
The warewasher and any other relevant additional devices must be connected in adherence to local standards and regu-
lations by an electrical company authorised by the relevant electricity supplier.
5.2.1 Water connection
The warewasher must be connected to the fresh water supply via the provided dirt trap, in order to achieve the water
safety level pursuant to DIN EN 61770.
The dirt trap prevents particles from the inlet water from entering the warewasher, thus preventing extraneous rust on the
cutlery and in the warewasher.
Connecting the supply hose
Important notes:
– The supply hose must not be shortened or damaged.
– Only use the supply hose provided. Old, pre-existing supply hoses must not be re-used.
– Do not kink the supply hose when installing it.
Item Name
1 UC-S inlet water connection
2 UC-M, UC-L, UC-XL inlet water connection
Ø Connect the supply hose (3) to the warewasher.
Ø Connect the dirt trap (2) to the local water supply (1).
Ø Connect the supply hose (3) to the dirt trap (2).
Ø Open the water supply (1) and check that the connec-
tions are sealed.
Connecting the warewasher to the waste water system
Ø Connect the waste water hose (1) to the warewasher.
Ø Guide and connect the waste water hose to the on-site
waste water connection.
To Next Page
Loading...
Need help?
General
