Operation | 6 | English
Operating instructions UC-Serie | 89014383; Version 2 | 37
Deactivating the additional programme
6.4 Soaking programme
We recommend the soaking programme for soaking and dissolving dried-on residues.
Activating the soaking programme
The soaking programme remains activated until it is deactivated and can be combined with another additional pro-
gramme.
Starting the soaking programme
WARNING
Risk of chemical burns due to chemicals
Contact of chemicals with the skin or eyes can lead to severe burns or serious eye damage.
Ø In the event of contact with the eyes or skin, wash thoroughly with tap water. If necessary, seek medical
attention.
Ø Wear protective clothing, protective gloves and protective goggles.
Ø Observe the danger and safety notes on the canister and safety data sheet.
Five seconds after the soaking programme has started, the wash pump circulates the tank water for seven seconds. The
soaking time of five minutes begins after this circulation. The tank water moistens the wash items and soaks the contam-
inants.
– If you open the door during this time and close it again within 10 seconds, the wash pump circulates the tank water
again for five seconds. The soaking time is not extended.
– If you open the door for longer than 10 seconds to put more wash items into the washing basket, the soaking pro-
gramme will start from the beginning once the door has been closed. A washing programme starts automatically after
the end of the soaking period. The soaking period can also be shortened by pressing the start button.
A service technician can adjust the times mentioned above.
Ø Remove the wash items only once the washing programme has finished and the start button flashes green.
Cancelling the soaking programme
After cancelling the soaking programme, always start a washing programme to rinse the tank water off the wash items.
To Next Page
Loading...
Need help?
General
