21
Owner’s Manual EN
10. Function Messages
Cutting grass cutting grass according to the program setting
Raining
The rain sensor detects water. Landroid
®
will return to the charging base
and stay there for the time you have programmed it to do so. When dry,
Landroid
®
will automatically begin the delay and countdown and then
return to mow. If you want Landroid
®
to mow before this, simply turn it off
then on again, but only when the rain sensor is dry or you can set the delay
time to 0 min.
Going home
needs to recharge—during the journey to the base, the cutting blade is
stopped in order to save energy
Charging charge is in progress—charge percentage are displayed
No working time scheduled stand-by, need to be programmed as desired.
Not working today stand-by, will start according to program set.
Work done today
Searching working area
According to the setting of “Customize work zone”, Landroid
®
is searching
a certain area to mow.
Charging 100% Landroid
®
has completed its charging.
Emergency charging Landroid
®
is charging in power-off state.
11. Error Messages
Message Cause Action
Outside working
area! Press
“START” to reset
Machine can’t find
boundary wire signal
or the direction of
boundary is wrong.
1. If Landroid
®
is actually outside its territory: turn power off, take Landroid
®
inside its territory. Turn power on. Press
.
2. If the Landroid
®
is inside its territory, check if the LED on the charging base
is green. If not, verify that the charging base is properly connected to the
charger and that the charger is connected to a suitable power supply. If they are
properly connected, the boundary wires are clamped incorrectly and must be
reversed.
3. Reverse the boundary wire ends.
Please enter right
PIN code
PIN code is wrong. Input the correct PIN or re-set your PIN.
Blade motor fault!
Press "START" to
reset
Blade disc is blocked.
1. Turn power off;
2. Turn Landroid
®
upside down and check if there’s anything preventing the
blade disc to rotate.
3. Remove any obstruction.
4.Turn Landroid
®
upright and take it to an area with short grass or adjust the
cutting height;
5. Turn power on. Press
.
Wheels motor fault!
Press "START" to
reset
Wheel motor is
blocked.
1.Turn power off; take Landroid
®
in an area free from obstacles;
2. Turn power on. Press
.
3. If the error message is still displayed; turn power off; turn Landroid
®
upside-down and check if there’s anything preventing the wheels from
rotating.
4. Remove any obstruction, turn Landroid
®
upright, turn power on.
To Next Page
Loading...
Need help?
General
