22
Owner’s Manual EN
Mower trapped!
Press "START" to
reset
Landroid
®
is trapped.
1. Turn power off;
2. Take Landroid
®
to an area in your lawn free of obstacles;
3. Turn power on. Press
.
4. If the error message is still displayed; turn power off; turn Landroid
®
upside-down. Check if there is anything preventing the wheels from
rotating.
5. Remove any obstruction, turn the Landroid
®
upright, turn power on.
Mower lifted! Press
"START" to reset
Landroid
®
is lifted up.
1. Turn power off.
2. Take Landroid
®
to a lawn area clear of obstacles, turn power on. Press .
3. If the error message is still displayed: turn power off, turn Landroid
®
upside-down and check there’s nothing lifted up.
4. Remove any possible object, turn Landroid
®
upright, turn power on.
Upside down! Press
“START” to reset
Landroid
®
is upside
down.
Turn Landroid
®
upright.
Battery voltage too
low.
Low battery.
In this case you must turn Landroid
®
off and place it in the charging base,
then “Charging” will be shown on screen, which means it starts charging.
Wire missing! Press
"START" to reset
Machine can’t find
boundary wire signal.
If the LED light flashes green, confirm that the boundary wire is well
connected to the clamps on the charging base. If the problem persists,
check that the boundary wire hasn’t been cut.
Battery charge
overtemp! Please
wait cooling down.
Temperature is too high
(more than 55
º
C) when
charging.
Place the charging base in a shady area or wait until the temperature
has cooled down.
Mower locked!
“Lock” function is
activated.
Put Landroid
®
in the original network and unlock it by setting “Enable lock”
to “disabled” in mobile App.
NOTES
• Before turning power on, always check Landroid
®
is inside its territory. If not, the message “Outside working area!
Press “START” to reset” will be displayed. This message is displayed also when Landroid
®
is sitting over the boundary
wire when turned on.
• If for any reason—i.e. a party, children playing...—you want to park your Landroid
®
in the charging base: press then
. Landroid
®
will go to its base and stay there. Please note Landroid
®
will now wait until the next scheduled mowing
session. If you want to re-start it, and press
then to start your Landroid
®
.
• If an error repeatedly occurs in the same area of your lawn, you might have a problem with the boundary wire so
please refer to the previous installation instructions and check your set up with its help.
• If your lawn is divided in two separated areas, connected by a corridor less than 1m, one of which is not provided with
the charging base: when Landroid
®
runs out of charge, take it manually to the charging base, turn power on, press
then
and the charge process will start.
• If Landroid
®
runs abnormally once in a while, please try to restart it. If the problem cannot be solved, please contact
WORX service agent for help.
• Do not wash your Landroid
®
with a high pressure washer. This could cause damage to the battery or the machine.
12. Security
If Landroid
®
is connected to your smartphone, you can lock it on your smartphone. This prevents unauthorised people from
being able to use it.
13. Troubleshooting
If your Landroid
®
does not work correctly, follow the troubleshooting guide below. If the issue persists, contact your Dealer.
Symptom Cause Action
The LED light on the charging
base does not turn on.
There is no power.
Check the charging base is connected
properly to the power adapter and the power
adapter is connected to a suitable power
supply.
To Next Page
Loading...
Need help?
General
