Phaser™ 4500 Laser Printer
Copyright © 2004 Xerox Corporation. All Rights Reserved.
4-24
Print-Quality Problems
This topic includes:
■ "Diagnosing Print-Quality Problems" on page 4-24
■ "Repeating Defects" on page 4-29
Your printer is designed to produce consistently high-quality prints. If you observe print-
quality problems, use the information on these pages to troubleshoot them.
For detailed, online support information, go to www.xerox.com/office/infoSMART.
Caution
If you change the type of paper in a tray, you must change the paper type and size on the
front panel to match the paper that you loaded. If you fail to do this, print-quality
problems can occur and the fuser can be damaged.
Diagnosing Print-Quality Problems
Caution
Damage caused by using unsupported paper, transparencies, and other specialty media is
not covered by the Xerox warranty, service agreement, or Total Satisfaction Guarantee.
The Total Satisfaction Guarantee is available in the United States and Canada. Coverage
may vary outside these areas; please contact your local representative for details.
Use the following table to find specific solutions to print-quality problems.
Diagnosing Print-Quality Problems
Problem Causes Solutions
Light Prints
The overall image is lighter
than normal.
1. The paper may be damp.
2. You may be using Draft
mode.
3. The toner level may be low.
1. Replace the paper.
2. Turn off Draft mode.
3. If the print cartridge is low on
toner, replace it.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General