To learn more about Xerox participation in sustainability initiatives, go to: www.xerox.com/environment.
Note: Changing the default Power Saver activation times can result in an overall higher energy consumption
of the device. Before you turn off Power Saver modes or set a long activation time, consider the increase in
device power consumption.
DEFAULT POWER SAVER SETTINGS
This device is ENERGY STAR
®
-qualified under the ENERGY STAR Program Requirements for Imaging Equipment. The
transition time from Ready mode to Low-Power mode can be set up to 60 minutes. The default value is 5 minutes.
The transition time from Low-Power mode to Sleep mode can be set up to 60 minutes. The default value is set at 1
minute. The total transition time from Ready mode to Sleep mode can take up to 60 minutes.
To change the Power Saver settings, contact your System Administrator, or refer to the System Administrator Guide
at www.xerox.com/support/VLB600_VLB610docs.
ENVIRONMENTAL BENEFITS OF DUPLEX PRINTING
Most Xerox products have duplex printing, also known as 2-sided printing, capability. This enables you to print on
both sides of the paper automatically, and therefore helps to reduce the use of valuable resources by reducing your
paper consumption. The Lot 4 Imaging Equipment agreement requires that on models greater than or equal to 40
ppm color or greater than or equal to 45 ppm monochrome the duplex function has been auto-enabled, during the
setup and driver installation. Some Xerox models below these speed bands may also be enabled with 2-sided
printing settings defaulted on at the time of install. Continuing to use the duplex function will reduce the
environmental impact of your work. However, should you require simplex/1-sided printing, you may change the
print settings in the print driver.
PAPER TYPES
This product can be used to print on both recycled and virgin paper, approved to an environmental stewardship
scheme, which complies with EN12281 or a similar quality standard. Lighter weight paper (60 g/m²), which contains
less raw material and thus saves resources per print, may be used in certain applications. We encourage you to
check if this is suitable for your printing needs.
REGULATORY INFORMATION FOR 2.4-GHZ AND 5-GHZ WIRELESS NETWORK ADAPTERS
This product contains a 2.4-GHz and 5-GHz Wireless LAN radio transmitter module that complies with the
requirements specified in FCC Part 15, Industry Canada RSS-210, and European Council Directive 2014/53/EU.
Radio Frequency (RF) output power of this device will not exceed 20 dBm in either frequency band.
Operation of this device is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications to this device not specifically approved by the Xerox Corporation may void the user's
authority to operate this equipment.
Xerox
®
VersaLink
®
B600/B610 Printer User Guide 187
Regulatory Information
To Next Page
Loading...
Need help?
General
Weight and Dimensions
