Xinje DP3C Series User Manual

23
Bit
Value
Explanation
8
0
switch off Touch probe 2
Stop/run Touch probe2
1
enable Touch probe 2
9
0
Trigger first event
Touch probe2 mode selection
(single/continuous)
1
Continuous
10
0
Trigger with Touch probe2 input
Touch probe2 trigger
selection
(external input/phase Z)
1
Trigger with zero impulse signal of position encoder
11
0
Reserved
not used
12
0
switch off sampling at positive edge of touch probe2
Touch probe 2 rising edge
selected
1
enable sampling at positive edge of touch probe2
13
0
switch off sampling at negative edge of touch probe2
Touch probe 2 falling edge
selected
1
enable sampling at negative edge of touch probe2
14-15
0
Reserved
The user can obtain the current state of the probe from the object 60B9h. The following is the description of bit
corresponding to 60B9h.
Bit
Value
Explanation
0
0
Touch probe1 is switch off
Probe 1 action stop
1
Touch probe1 is enabled
Probe 1 in action
1
0
Touch probe1 no positive edge value stored
Rising edge probe 1
incomplete status
1
Touch probe1 positive edge value stored
Rising edge probe 1
completion status
2
0
Touch probe1 no negative edge value stored
Falling edge probe 1
incomplete state
1
Touch probe1 negative edge value stored
Falling edge probe 1
completion status
3-5
-
reserved
not used
6-7
-
Not supported
not used
8
0
Touch probe2 is switch off
Probe 2 action stop
1
Touch probe2 is enabled
Probe 2in action
9
0
Touch probe2 no positive edge value stored
Rising edge probe
2incomplete status
1
Touch probe2 positive edge value stored
Rising edge probe 2
completion status
10
Touch probe2 no negative edge value stored
Falling edge probe 2
incomplete state
Touch probe2negative edge value stored
Falling edge probe 2
completion status
11-13
-
Reserved
not used
14-15
-
Not supported
not used

Xinje DP3C Series Specifications

General

Brand	Xinje
Model	DP3C Series
Category	Servo Drives
Language	English