5.8 GEARBOX MATCH
After changing the gearbox or changing the gearbox ECU, you need to
use the gearbox matching function to re-match the engine and the
gearbox.
Before resetting the gearbox, please check the gearbox control unit to ensure that there is no
fault code. If there is a fault code, the gearbox memory function cannot be reset. Please road
test after reset.
The operation guidelines of the Gearbox Matching function are
shown below:
1. Enter the Gearbox matching menu and choose relevant models
according to the vehicle being tested.
2. Enter the Reset adaptive value menu.
3. Turn on the ignition without starting the engine.
4. Read the note and press OK to continue the Gearbox Matching
function.
Figure 5-26 Sample of gearbox matching function (screen 1)
5. Wait until the message ‘Successful operation’ pops up.
To Next Page
Loading...
Need help?
General
