22 VR-120D OPERATING MANUAL
Memory Mode
MEMORY RECALL
Recall of memorized channels is very simple:
1. Press the [V/M] key to enter the Memory mode. The memory
number will appear in the top left-hand corner of the display,
indicating that you are now operating in the Memory Recall
mode.
2. Rotate the DIAL knob to select the desired memory channel.
3. Rotate the DIAL knob, while pressing the [FUNC] key, to recall the first memory
channel of each memory bank.
4. To return to the VFO mode from the Memory mode, just press the [V/M] key.
LABELING MEMORIES
You may wish to append an alpha-numeric "Tag" (label) to a memory or memories, to aid
in recollection of the channel frequency's significance (such as a Broadcast Station name,
etc.). Alpha-numeric labels may be appended at the time of storage of the frequency data,
or at a later time. In either case, the storage process is basically identical.
An example of alpha-numeric label programming was presented earlier in detailed form.
The section to follow will summarize the process.
To label a previously-stored memory channel:
1. Recall the memory channel on which you wish to append a label.
2. Press the [SCAN] key while pressing the [FUNC] key to
enable programming of the name tag. You will notice the first
entry's place blink.
3. Rotate the DIAL to select the first digit of the desired label.
4. Rotate the DIAL knob clockwise while pressing the [FUNC]
key to move the next character. Now release the [FUNC]
key.
5. Repeat steps (3.) to (4.) to program the remaining letters or
numbers of the desired label. A total of six characters may be used in the creation of a
label.
6. When you have completed the creation of the label, press the [V/M] key, while press-
ing the [FUNC] key, to save the label.
space Þ A ・・・ZÞ 0 ・・・9 Þ * Þ + Þ − Þ / Þ < Þ > Þ Þ space Þ A ・・・Z・・・
To Next Page
Loading...
Need help?
General
