25VR-120D OPERATING MANUAL
Memory Mode
DELETING MEMORY CHANNELS
You may wish to delete a certain Memory Channel's data, when you no longer have a
reason to recall that channel.
To delete a channel's data:
1. Recall the Memory Channel to be deleted.
2. Press the [V/M] key while pressing the [FUNC] key. You
will observe "CLEAR" on the display.
3. Press the [V/M] key again, while pressing the [FUNC] key,
to delete the Memory Channel.
Important Note: Deleted Memory Channel data cannot be restored.
CLEARING OF A MEMORY BANK
This feature allows you to clear (discard) the data from all memory channels in a desired
memory bank at the same time.
1. Set the radio to the VFO mode by pressing the [V/M] key.
2. Press the [SCAN] key, while pressing the [FUNC] key, to activate the "Set" (Menu)
mode.
3. Rotate the DIAL knob to select Menu #16 [BANKCL].
4. Rotate the DIAL knob one click clockwise while pressing the [FUNC] key to select
the desired Memory Bank.
5. The display will now indicate "CLEAR" for about four seconds. Thereafter, clearing
of the prescribed Memory Bank will be complete.
6. Press the [SCAN] key while pressing the [FUNC] key to exit to normal operation.
Important Note: A cleared Memory Bank can not have its channels' data restored. All
data for that bank will have to be re-entered.
To Next Page
Loading...
Need help?
General
