32 VR-120D OPERATING MANUAL
Occasionally, a static discharge or other anomaly will cause the microprocessor to go into
erratic behavior. This can frequently be corrected by a "System Reset" whereby the micro-
processor is cleared of all "soft" data. If you just want to clear the Menu and Function
Mode settings to their factory defaults, without losing your frequency memories, use the
"Function/Menu Reset" procedure.
SYSTEM RESET
(To reset the Function mode and Set (Menu) mode settings to their factory defaults)
1. Turn the radio off.
2. Press and hold in the [FUNC] and [MONI] keys while turning the radio on (press the
[V/M] key at this time to cancel the Reset procedure).
3. Press the [V/M] key, while pressing the [FUNC] key, to reset the all settings to their
factory defaults.
ALL RESET
(To clear all memories and other settings to factory defaults)
1. Turn the radio off.
2. Press and hold the [FUNC], [MONI] and [BNDs] keys while turning the radio on
(press the [V/M] key at this time to cancel the Reset procedure).
3. Press the [V/M] key, while pressing the [FUNC] key, to reset the all settings to their
factory defaults.
Reset Procedures
To Next Page
Loading...
