Yaesu VR-5000 User Manual

VR-5000 OPERATING MANUAL 27
To install a Memory Channel into the PMR Board:
1. Recall the memory channel which you wish to be monitoring for activity.
2. Press the
[
F
]
key momentarily, then press the
[
3
(
S.SCH
)]
key.
3. The next-available PMR Board channel slot will be displayed, with an arrow alongside
it. Press the
[
•
(
BEEP
)]
key to store the current channel.
4. Rotate the DIAL knob to set the cursor to the “END” menu selection, then press the
[
ENT
(
SET
)]
key.
5. Confirm that the cursor is on the “WRITE” menu selection, then press the
[
ENT
(
SET
)]
key to install the memory channel into the PMR Board.
6. Repeat steps 1 ~ 5 to install any other desired memory channels (up to 50 channels)
into the PMR Board.
To monitor the PMR Board:
Before commencing operation in this mode, be sure that the SQL control is set up so as to
quiet the background noise.
1. Press the
[
F
]
key momentarily, then press the
[
4
(
SPL
)]
key.
2. Rotate the DIAL knob to set the cursor to the “PMR Board” menu selection, then press
the
[
ENT
(
SET
)]
key.
3. The PMR Board will now be displayed as a matrix of channel squares. The “White”
squares indicate vacant channels, and Black squares indicate occupied channels.
4. Press the
[
CLR
(
PRI CLR
)]
key, followed by the
[
ENT
(
SET
)]
key, to return to the
Memory mode.
To delete a memory channel from the PMR Board:
1. Recall the Memory Channel mode.
2. Press the
[
F
]
key momentarily, then press the
[
3
(
S.SCH
)]
key.
3. Rotate the DIAL knob to set the cursor to the memory channel which you wish to delete
from the PMR Board, then press the
[
•
(
BEEP
)]
key.
4. Rotate the DIAL knob to select the cursor to the “END” menu, then press the
[
ENT
(
SET
)]
key .
5. Confirm that the cursor is on the “WRITE” menu, then press the
[
ENT
(
SET
)]
key to
delete the memory channel from the PMR Board and return to the Memory mode.
Memory Operation

Yaesu VR-5000 Specifications

General

Brand	Yaesu
Model	VR-5000
Category	Receiver
Language	English