Yaesu VR-5000 User Manual

VR-5000 OPERATING MANUAL22
Memory Operation
ENHANCED MEMORY CHANNEL OPERATION
Memory Offset Tuning
Once you have recalled a particular memory channel, you may easily tune off that channel,
as through you were in the “VFO” mode.
1. With the VR-5000 in the memory mode, select the desired memory channel.
2. Press the
[
BS
(
BS SET
)
MT
]
key momentarily.
3. Rotate the DIAL knob or press the
[

(

)
/
(

)]
keys, as desired, to tune to a new
frequency.
4. If you wish to return to the original memory frequency, press the
[
V/M
(
MW
)]
key
momentarily.
5. Press the
[
COPY
(
REC
)]
key to return to the VFO on the new frequency set during
Memory Tuning.
Naming Memories
You may wish to append an alpha-numeric “Tag” (label) to a memory or memories, to aid
in recollection of the channel frequency’s identity (such as a Short-wave Broadcast station’s
name, etc.).
1. Recall the memory channel on which you wish to append a label.
2. Press the
[
F
]
key momentarily, then press the
[
V/M
(
MW
)]
key.
3. Rotate the DIAL knob to set the cursor to the “CH TAG” menu, then press the
[
ENT
(
SET
)]
key to enable programming of the name tag into the memory.
4. Press the keypad to select the first digit of the desired label, according to the key entry
rule described below. When you have made your selection, rotate the DIAL knob clock-
wise one click to move to the next character.
5. Repeat the previous step to program the remaining letters, numbers, or symbols of the
desired label. A total of 74 characters may be used in the creation of label.
6. When you have completed the label, press the
[
ENT
(
SET
)]
key.
7. Rotate the DIAL knob to set the cursor to the “END” menu selection, then press the
[
ENT
(
SET
)]
key.
8. Confirm that the cursor is on the “WRITE” menu option, then press the
[
ENT
]
key.
9. The naming of the memory is now complete.

Yaesu VR-5000 Specifications

General

Brand	Yaesu
Model	VR-5000
Category	Receiver
Language	English