Yamaha 2006 Virago XV250V User Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
6-33
6
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the wheel axle to the spec-
ified torque.
6. Tighten the front wheel axle pinch
bolt to the specified torque.
7. While applying the front brake,
push down hard on the handlebars
several times to check if the front
fork compresses and rebounds
smoothly.
8. Connect the speedometer cable.
EAU25080
Rear wheel
EAU32750
To remove the rear wheel
WARNING
EWA10820
● It is advisable to have a Yamaha
dealer service the wheel.
● Securely support the motor-
cycle so that there is no danger
of it falling over.
1. Remove the axle nut cotter pin.
2. Loosen the chain puller locknut
and the drive chain slack adjusting
nut on both ends of the swingarm.
1. Speedometer gear unit
2. Retainer
3. Speedometer cable
Tightening torque:
Wheel axle:
59 Nm (5.9 m·kgf, 43 ft·lbf)
Tightening torque:
Front wheel axle pinch bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
U2UJ23E0.book Page 33 Wednesday, May 11, 2005 11:30 AM

Yamaha 2006 Virago XV250V Specifications

General

Brand	Yamaha
Model	2006 Virago XV250V
Category	Motocycles
Language	English