Name: Yamaha 2B
Brand: Yamaha
Rating: 5 (1 reviews)

To Next Page

To Previous Page

3-20

ADJUSTING TRIM ANGLE

There are 5 holes (2/9.9/15-hp model: 4

holes) provided in the engine bracket to

adjust the outboard motor trim angle.

To adjust the trim angle, first stop the

engine. Then, remove the adjusting rod

from the engine bracket assembly and —

while tilting the motor — reposition the

rod in the desired hole.

To raise the bow (“trim-out”), move the

rod away from the transom. To lower the

bow (“trim-in”), move the rod toward the

transom. Make test runs with the trim set

to different angles to find the position that

works best for your boat and operating

conditions.

8 Stop the engine before adjusting the

trim angle.

8 Use care to avoid being pinched when

removing or installing the rod.

8 Use caution when trying a trim position

for the first time. Increase speed gradu-

ally and watch for any signs of instabili-

ty or control problems. Improper trim

angle can cause loss of control.

1 Trim angle adjusting rod

NOTE:

The outboard motor trim angle can be

changed approximately 4 degrees by

shifting the trim adjusting-rod one hole.

4/5

6A1-9-7LA0-3B 3/7/02 12:15 PM Page 88

Questions and Answers:

Need help?

Do you have a question about the Yamaha 2B and is the answer not in the manual?

Yamaha 2B Specifications

General