Operation
38
should supply oil normally. If no oil is
flowing after 10 minutes of idling, consult
your Yamaha dealer.
NOTICE
ECM00130
Be sure to take the above steps when op-
erating the engine after a long period of
storage. Otherwise engine seizure could
occur.
EMU36953
Install cowling
1. Be sure that a cowling lock lever is re-
leased.
2. Be sure that the rubber seal is seated all
the way around the top cowling.
3. Place the top cowling on bottom cowl-
ing.
4. Check to be sure the rubber seal fits cor-
rectly all the way around the engine.
5. Move the lever to lock the cowling as
shown.
NOTICE:
If the cowling is not
installed correctly, water spray under
the cowling can damage the engine,
or the cowling can blow off at high
speeds.
[ECM01990]
After installing, check the fitting of the top
cowling by pushing it with both hands. If the
top cowling is loose, have it repaired by your
Yamaha dealer.
EMU34581
Power trim and tilt system
WARNING
EWM01930
●
Never get under the lower unit while it
is tilted, even when the tilt support lever
is locked. Severe injury could occur if
the outboard motor accidentally falls.
●
Body parts can be crushed between the
motor and the clamp bracket when the
motor is trimmed or tilted.
●
Be sure no one is near the outboard
motor before performing this check.
1. Check the power trim and tilt unit for any
sign of oil leaks.
ZMU03367
ZMU06109
To Next Page
Loading...
Need help?
General
