Trouble Recovery
75
wheel or other moving parts when the
engine is running. Do not install the
starter mechanism or top cowling after
the engine is running.
●
Do not touch the ignition coil, spark
plug wire, spark plug cap, or other elec-
trical components when starting or op-
erating the motor. You could get an
electrical shock.
EMU29574
Emergency starting engine
1. Remove the top cowling.
2. Disconnect the start-in-gear protection
cable from the starter, if equipped.
3. Remove the starter/flywheel cover after
removing the bolt(s).
4. Prepare the engine for starting. For fur-
ther information, see page 42. Be sure
the engine is in neutral and that the clip
is attached to the engine shut-off switch.
The main switch must be “” (on), if
equipped.
5. Insert the knotted end of the emergency
starter rope into the notch in the flywheel
rotor and wind the rope several turns
around the flywheel clockwise.
6. Pull the rope slowly until resistance is
felt.
7. Give a strong pull straight out to crank
and start the engine. Repeat if neces-
sary.
ZMU03425
ZMU03139
ZMU03140
OFF
ZMU03541
ON
ZMU03429
To Next Page
Loading...
Need help?
General
