Operation
42
tank cap, loosen it 2 or 3 turns.
2. If there is a fuel joint on the motor, firmly
connect the fuel line to the joint. Then
firmly connect the other end of the fuel
line to the joint on the fuel tank.
IP:
Wipe up any spilled gasoline immediately
with dry rags. Dispose rags properly accord-
ing to local laws or regulations.
3. If a steering friction adjuster is provided
on your outboard motor, securely attach
the fuel line to the fuel line clamp.
4. Squeeze the primer pump, with the ar-
row pointing up, until you feel it become
firm. During engine operation place the
tank horizontally, otherwise fuel cannot
be drawn from the fuel tank.
EMU27493
Starting engine
WARNING
EWM01600
Before starting the engine, make sure
that the boat is tightly moored and that
you can steer clear of any obstructions.
Be sure there are no swimmers in the wa-
ter near you.
EMU27595
Electric start / prime start models
WARNING
EWM01840
●
Failure to attached engine shut-off cord
could result in a runaway boat if opera-
tor is ejected. Attach the engine shut-
off cord to a secure place on your cloth-
ing, or your arm or leg while operating.
Do not attach the cord to clothing that
could tear loose. Do not route the cord
where it could become entangled, pre-
ZMU02295
ZMU03100
ZMU02024
1. Arrow
To Next Page
Loading...
Need help?
General
