Maintenance
64
tion in the boat. Install a fully charged bat-
tery in the holder.
CAUTION:
ECM01122
●
Make sure the main switch (on applica-
ble models) is “” (off) before work-
ing on the battery.
●
Reversal of the battery cables will dam-
age the electrical parts.
●
Connect the red battery cable first
when installing the battery and discon-
nect the black battery cable first when
removing it.
●
The electrical contacts of the battery
and cables must be clean and properly
connected, or the battery will not start
the engine.
Connect the red battery cable to the POSI-
TIVE (+) terminal first. Then connect the
black battery cable to the NEGATIVE (-) ter-
minal.
EMU29370
Disconnecting the battery
Disconnect the BLACK cable from the NEG-
ATIVE (-) terminal first. Then disconnect the
RED cable from the POSITIVE (+) terminal.
EMU29391
Checking top cowling
CAUTION:
ECM01650
Be sure the cowling is closed securely
and that there are no gaps. A loose or im-
properly fitting cover could allow water
into the engine.
Check the fitting of the top cowling by push-
ing it with both hands. If it is loose have it re-
paired by your Yamaha dealer.
EMU29400
Coating the boat bottom
A clean hull improves boat performance. The
boat bottom should be kept as clean of ma-
rine growth as possible. If necessary, the
boat bottom can be coated with an anti-foul-
ing paint approved for your area to inhibit
marine growth.
Do not use anti-fouling paint which includes
copper or graphite. These paints can cause
more rapid engine corrosion.
1. Red cable
2. Black cable
3. Battery
To Next Page
Loading...
Need help?
General
