CHK
ADJ
Periodic checks and adjustments
3-5
6D93G11
2. Remove the oil dipstick and oil filler cap
1
.
3. Place a drain pan under the drain hole,
and then remove the drain bolt
2
and let
the oil drain completely.
NOTE:
Be sure to clean up any oil spills.
4. Install the drain bolt, and then tighten it to
the specified torque.
5. Pour the specified amount of the recom-
mended engine oil into the oil filler hole.
6. Install the oil filler cap and oil dipstick,
and then start the engine and warm it up
for 5 minutes.
7. Turn the engine off, and then check the
oil level and correct it if necessary.
Replacing the oil filter
1. Extract the engine oil with an oil changer
or drain it.
2. Place a rag under the oil filter, and then
remove the oil filter using the oil filter
wrench.
NOTE:
• Wait more than 5 minutes after turning the
engine off to replace the oil filter.
• Be sure to clean up any oil spills.
3. Apply a thin coat of engine oil to the O-
ring of the new oil filter.
4. Install the oil filter, and then tighten it to
the specified torque using the oil filter
wrench.
T
R
.
.
Engine oil drain bolt:
27 N·m (2.7 kgf·m, 20.0 ft·lb)
Recommended engine oil:
4-stroke motor oil
API: SE, SF, SG, SH, or SJ
SAE: 10W-30 or 10W-40
Engine oil quantity:
Without oil filter replacement:
4.3 L (4.55 US qt, 3.78 Imp qt)
S60C3060
1
Oil filter wrench 64: 90890-01426
S6D83050
To Next Page
Loading...
Need help?
General
