9-3
MODEL NAME DESIGNATION
The model primary ID that consists of the model name, prefix model code, transom length and serial
number is stamped on the label attached to the clamp bracket.
* The serial number is a 7-digit sequential numbering scheme irrespective of model variation and transom
length.
GLOBAL MODELS IDENTIFICATION CODE
The model identification has been standardized as follows since 1998 model year.
FL 350 A ET U
Model category
Output
(PS)
Model
generation
Model variation
Transom height
(Drive shaft length)
Non: 2-stroke STD engine
D: Twin rotating prop
E: Enduro series
F: 4-stroke engine
K: Kerosene engine
L: L/H rotation series
T: High thrust (4-stroke)
Z: HPDI engine
2
to
350
A
B
C
D
F
G
H
J
L
N
P
Q
R
S
T
U
V
X
Y
(Repeat
from A)
Level 1: Start system
M: Manual start
E: Electric start
W: Electric & Manual start
Level 2: Control system
Blank: Remote control
H: Tiller handle
C: Remote control w/ tiller handle
Level 3: Trim & Tilt system
Blank: Manual tilt
D: Hydro tilt
P: Power tilt
T: Power trim & tilt
Level 4: Lubrication system
[2-stroke engine]
Blank: Premixed fuel engine
O: Oil injection engine
S (15”)
L (20”)
Y (22.5”)
X (25”)
U (30”)
YAMAHA MOTOR CO., LTD.
MADE IN JAPAN
PAYS D'ORIGINE JAPON
6AX
FL350AET
U
Prefix model code
Transom height
Model name
Serial number
To Next Page
Loading...
Need help?
General
