Yamaha FJR1300 User Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
6-13
6
5. Install and tighten the filler bolt.
6. Check the final gear case for oil
leakage. If oil is leaking, check for
the cause.
EAU04861
Checking the coolant level
The coolant level should be checked as
follows before each ride. In addition,
the coolant must be changed at the in-
tervals specified in the periodic mainte-
nance and lubrication chart.
1. Place the motorcycle on the cen-
terstand.
NOTE:
_
●
The coolant level must be checked
on a cold engine since the level
varies with engine temperature.
●
Make sure that the motorcycle is
positioned straight up when
checking the coolant level. A slight
tilt to the side can result in a false
reading.
_
2. Check the coolant level in the
coolant reservoir.
NOTE:
_
The coolant should be between the
minimum and maximum level marks.
_
Recommended final gear oil:
Shaft drive gear oil
(Part No.: 9079E-SH001-00)
Oil quantity:
0.2 L
1. Maximum level mark
2. Minimum level mark
U5JWE2.book Page 13 Wednesday, November 6, 2002 3:32 PM

Yamaha FJR1300 Specifications

General

Displacement	1298cc
Compression Ratio	10.8:1
Final Drive	Shaft
Wheelbase	60.8 in
Fuel Capacity	6.6 gal
Bore x Stroke	79.0mm x 66.2mm
Fuel System	Fuel Injection
Ignition	TCI
Rear Suspension	Single shock, 4.9-in travel
Front Brakes	Dual 320mm discs
Rear Brakes	282mm disc
Front Tire	120/70ZR17
Rear Tire	180/55ZR17
Seat Height	31.7 in or 32.5 in
Curb Weight	642 lb