Yamaha FJR1300 User Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
6-16
6
5. Lightly tap the air filter element to
remove most of the dust and dirt,
and then blow the remaining dirt
out with compressed air as shown.
If the air filter element is damaged,
replace it.
6. Insert the air filter element into the
air filter case.
EC000082*
CAUTION:
_
●
Make sure that the air filter ele-
ment is properly seated in the
air filter case.
●
The engine should never be op-
erated without the air filter ele-
ment installed, otherwise the
pistons and/or cylinders may
become excessively worn.
_
7. Install the air filter case cover by
installing the screws.
8. Install the intake air shroud by in-
stalling the quick fastener screws.
9. Install the panel.
EAU04033
Checking the engine idling
speed
The engine idling speed must be
checked as follows and, if necessary,
adjusted by a Yamaha dealer at the in-
tervals specified in the periodic mainte-
nance and lubrication chart.
Start the engine and warm it up for
several minutes at 1,000–2,000 r/min
while occasionally revving it to
4,000–5,000 r/min.
NOTE:
_
The engine is warm when it quickly re-
sponds to the throttle.
_
Engine idling speed:
1,000–1,100 r/min
U5JWE2.book Page 16 Wednesday, November 6, 2002 3:32 PM

Yamaha FJR1300 Specifications

General

Displacement	1298cc
Compression Ratio	10.8:1
Final Drive	Shaft
Wheelbase	60.8 in
Fuel Capacity	6.6 gal
Bore x Stroke	79.0mm x 66.2mm
Fuel System	Fuel Injection
Ignition	TCI
Rear Suspension	Single shock, 4.9-in travel
Front Brakes	Dual 320mm discs
Rear Brakes	282mm disc
Front Tire	120/70ZR17
Rear Tire	180/55ZR17
Seat Height	31.7 in or 32.5 in
Curb Weight	642 lb