Yamaha MT-10 SP User Manual

Instrument and control functions
5-2
1
2
3
4
5
6
7
8
9
10
11
12
13
To unlock the steering
Push the key in and turn it to “OFF”.
EAU66057
Handlebar switches
Left
Right
EAU91630
Dimmer/Pass switch “ / /PASS”
Set this switch to “ ” for the high
beam and to “ ” for the low beam.
While the headlight is set on low beam,
push the switch down towards “PASS”
to flash the high beam and to mark the
start of each lap when using the lap tim-
er.
1. Push.
2. Turn.
12
1. “MODE” switch
2. MODE up “ ” switch
3. MODE down “ ” switch
4. Cruise control/YVSL switches
5. Hazard switch “ ”
6. Horn switch “ ”
7. Turn signal switch “ / ”
8. Dimmer/Pass switch “ / /PASS”
RES
SET
MODE
PASS
23
4
5
6
1
8
7
1. Stop/Run/Start switch “ / / ”
2. Wheel switch “ ”
111
22
BGG-9-10-E0.book 2 ページ ２０２２年１月２６日 水曜日 午前１１時３７分

Yamaha MT-10 SP Specifications

General

Engine Type	Liquid-cooled, 4-stroke, DOHC, 4-valve
Bore x Stroke	79.0 mm x 50.9 mm
Compression Ratio	12.0:1
Fuel System	Fuel injection
Transmission	6-speed
Final Drive	Chain
Front Tire	120/70ZR17M/C (58W)
Rear Tire	190/55ZR17M/C (75W)
Wheelbase	1, 405 mm
Seat Height	835 mm
Length	2, 095 mm
Width	800 mm
Minimum Ground Clearance	135 mm
Maximum Torque	111.0 Nm (11.3 kg-m) @ 9, 000 rpm
Front Brakes	Dual 320 mm hydraulic disc, ABS
Rear Brakes	220 mm hydraulic disc, ABS
Fuel Capacity	17 liters