Yamaha MT-10 SP User Manual

Instrument and control functions
5-34
1
2
3
4
5
6
7
8
9
10
11
12
13
2. Push the rear of the seat down to
lock it in place.
3. Remove the key.
TIP
Make sure that the seat is properly se-
cured before riding.
NOTICE
ECA27380
The IMU is located under the seat. It
is not user serviceable and very sen-
sitive, so we advise against handling
the IMU directly.
 Do not remove, modify, or place
any foreign materials in or
around the IMU.
 Do not subject the IMU to strong
shocks.
EAU94871
Adjusting the front fork
NOTICE
ECA22472
 Use extra care to avoid scratch-
ing the anodized finish when
making suspension adjust-
ments.
 To avoid damaging the suspen-
sion’s internal mechanisms, do
not attempt to turn beyond the
maximum or minimum settings.
This model is equipped with ÖHLINS
electronic racing suspension. The com-
pression and rebound damping forces
are electronically adjusted (see ERS on
page 5-19). The spring preload is man-
ually adjusted.
Spring preload
1. Turn the vehicle off.
2. Slide the rubber cover back at
each coupler.
3. Remove the coupler on each front
fork. NOTICE: To prevent dam-
aging the couplers, do not use
sharp tools or excessive
force.
[ECA22770]
1. Projection
2. Seat holder
2
2
2
2
1
BGG-9-10-E0.book 34 ページ ２０２２年１月２６日 水曜日 午前１１時３７分

Yamaha MT-10 SP Specifications

General

Engine Type	Liquid-cooled, 4-stroke, DOHC, 4-valve
Bore x Stroke	79.0 mm x 50.9 mm
Compression Ratio	12.0:1
Fuel System	Fuel injection
Transmission	6-speed
Final Drive	Chain
Front Tire	120/70ZR17M/C (58W)
Rear Tire	190/55ZR17M/C (75W)
Wheelbase	1, 405 mm
Seat Height	835 mm
Length	2, 095 mm
Width	800 mm
Minimum Ground Clearance	135 mm
Maximum Torque	111.0 Nm (11.3 kg-m) @ 9, 000 rpm
Front Brakes	Dual 320 mm hydraulic disc, ABS
Rear Brakes	220 mm hydraulic disc, ABS
Fuel Capacity	17 liters