Yamaha MT-10 SP User Manual

Periodic maintenance and adjustment
8-24
1
2
3
4
5
6
7
8
9
10
11
12
13
EAU22734
Changing the brake fluid
Have a Yamaha dealer change the
brake fluid every 2 years. In addition,
have the seals of the master cylinders
and brake calipers, as well as the brake
hoses replaced at the intervals listed
below or sooner if they are damaged or
leaking.
 Brake seals: every 2 years
 Brake hoses: every 4 years
EAU22762
Drive chain slack
The drive chain slack should be
checked before each ride and adjusted
if necessary.
EAU74253
To check the drive chain slack
1. Place the motorcycle on the sides-
tand.
TIP
When checking and adjusting the drive
chain slack, there should be no weight
on the motorcycle.
2. Shift the transmission into the neu-
tral position.
3. Measure the drive chain slack as
shown.
4. If the drive chain slack is incorrect,
adjust it as follows. NOTICE: Im-
proper drive chain slack will
overload the engine as well as
other vital parts of the motorcy-
cle and can lead to chain slip-
page or breakage. To prevent
this from occurring, keep the
drive chain slack within the
specified limits.
[ECA10572]
EAU74260
To adjust the drive chain slack
Consult a Yamaha dealer before ad-
justing the drive chain slack.
1. Drive chain slack
Drive chain slack:
20.0–30.0 mm (0.79–1.18 in)
111
BGG-9-10-E0.book 24 ページ ２０２２年１月２６日 水曜日 午前１１時３７分

Yamaha MT-10 SP Specifications

General

Engine Type	Liquid-cooled, 4-stroke, DOHC, 4-valve
Bore x Stroke	79.0 mm x 50.9 mm
Compression Ratio	12.0:1
Fuel System	Fuel injection
Transmission	6-speed
Final Drive	Chain
Front Tire	120/70ZR17M/C (58W)
Rear Tire	190/55ZR17M/C (75W)
Wheelbase	1, 405 mm
Seat Height	835 mm
Length	2, 095 mm
Width	800 mm
Minimum Ground Clearance	135 mm
Maximum Torque	111.0 Nm (11.3 kg-m) @ 9, 000 rpm
Front Brakes	Dual 320 mm hydraulic disc, ABS
Rear Brakes	220 mm hydraulic disc, ABS
Fuel Capacity	17 liters