En 9
a MAIN ZONE z key
Turns on/off (standby) the unit.
b Standby indicator
Lights up when the unit is in standby mode under any of the following conditions.
• HDMI Control is enabled (p.117)
• Standby Through is enabled (p.118)
• Network Standby is enabled (p.119)
c ZONE 2 key
Enables/disables the audio output to Zone2 (p.90).
d ZONE CONTROL key
Changes the zone (main zone or the Zone2) that is controlled by the keys and knobs on the front panel
(p.90).
e INFO (WPS) key
Selects the information displayed on the front display (p.96).
Enters the wireless network connection setup (WPS push button configuration) by holding down for 3
seconds (p.55).
f MEMORY key
Registers FM/AM radio stations as preset stations (p.71).
g PRESET keys
Select a preset FM/AM radio station (p.71).
h FM and AM keys
Switch between FM and AM (p.70).
i Front display
Displays information (p.12).
j Remote control sensor
Receives remote control signals (p.5).
k TUNING keys
Select the radio frequency (p.70).
l PURE DIRECT key
Enables/disables Pure Direct (p.69).
m INPUT knob
Selects an input source.
n PHONES jack
For connecting headphones.
o YPAO MIC jack
For connecting the supplied YPAO microphone (p.45).
p TONE CONTROL key
Adjusts the high-frequency range and low-frequency range of output sounds (p.98).
q SCENE keys
Select the registered input source, sound program, and various settings with one touch. Also, turns on
the unit when it is in standby mode (p.63).
r PROGRAM keys
Select a sound program or a surround decoder (p.64).
s STRAIGHT (CONNECT) key
Enables/disables the straight decode mode (p.68).
Enters MusicCast CONTROLLER registration by holding down for 5 seconds (p.61).
t VIDEO AUX (HDMI IN) jack
For connecting a device, such as a camcorder and a game console (p.38).
u USB jack
For connecting a USB storage device (p.76).
v VOLUME knob
Adjusts the volume.
To Next Page
Loading...
Need help?
General