Installing a microSDHC Card (not included)
Power o your phone before installing or removing a
microSDHC card.
1. Place your nger in the slot at the bottom of the back cover to
lift and remove the cover. If the battery is installed, remove it.
2. Hold your microSDHC card with the metal contacts facing
down and slide it into the microSDHC card slot.
3. Insert the battery by aligning the metal contacts on the
battery with the metal contacts in the battery compartment.
Gently push down on the battery until it clicks into place.
4. Replace the back cover.
Charging the Battery
Your phone’s battery should have enough power for the phone
to turn on, nd a signal, and make a few calls. You should fully
charge the battery as soon as possible.
WARNING! Use only ZTE-approved chargers and cables. The use
of unapproved accessories could damage your phone or cause
the battery to explode.
1.
Connect the adapter to the charging port.
2. Connect the charger to a standard AC wall outlet. If the phone is
on, you’ll see a charging icon, such as or , appear in the Status Bar.
3. Disconnect the charger when the battery is fully charged.
4
Getting Started
5
To Next Page
Loading...
Need help?
General
