ZXV10 W615 User Manual
Confidential and Proprietary Information of ZTE CORPORATION 13
Parameter Description
Enable Verify AC Enables or disables the AC verification function when
WAN Type is DHCP.
Enable VLAN Enables or disables the VLAN configuration function.
Virtual Local Area Network (VLAN)
Identification/Identity/Identifier (ID) and 802.1p are used
to set the VLAN and priority for the selected device.
VLAN ID Indicates the VLAN ID of packets through the WAN
interface. The value range is 0-4094.
802.1p Specifies the processing priority. It only applies to
multiple WAN connections. The range is 0-7 and the
default value is 0, which means no priority. A greater
value indicates a higher priority.
Enable DSCP Enables or disables the Differential Services Code Point
(DSCP) function for data flow.
DSCP Specifies the DSCP value. The value range is 0-63.
MTU Specifies the Maximum Transmission Unit (MTU) value.
The default value is 1448.
3. Click Submit.
Notes:
The configuration on this page takes effect after the device is restarted.
—END OF STEPS—
Configuring a Broadband Connection (Fat AP)
This section describes how to configure a broadband connection for fat AP.
Steps
The AP mode of the device is Fat.
1. Select Network > WAN > WAN Connection. The following page is
displayed.
To Next Page
Loading...
Need help?
General
