ZXV10 W615 User Manual
Confidential and Proprietary Information of ZTE CORPORATION 45
2. Configure the parameters. Refer to the following table.
Parameter Description
WAN Connection Specifies the required interface.
Network Address Refers to the address of the destination network.
Subnet Mask Refers to the subnet mask of the destination network.
Gateway Refers to the IP address of the gateway (next hop).
Modify
Click to edit the corresponding static route rule.
Delete
Click to delete the corresponding static route rule.
3. Click Add.
—END OF STEPS—
Setting an IPv6 Static Route
This section describes how to configure an IPv6 static route.
Steps
1. Select Network > Routing > Static Routing (IPv6). The following page is
displayed.
To Next Page
Need help?
General
