2.4.2 ADJUSTING ANGLE OF THE CAMERA
Adjust the camera to the desired angle by unscrewing the joints referring to the following pictures.
Steps:
1). Insert the video output cable (included in the
package) to the video output cable socket, and
connect it to an analogue video test monitor to
check if the camera angle has been set as
intended. If the angle is appropriate, disconnect
the camera from the analogue monitor, and then
remove the video output cable from the camera.
2.4.3 ADJUSTING ZOOM AND FOCUS (VX-2A-B-
IWD MODEL ONLY)
Steps:
1). Unscrew the zoom puller and the focus puller
counter-clockwise.
2). Adjust the zoom and the focus of the lens.
3). Tighten the zoom puller and the focus puller again by
turning it clockwise after the zoom and the focus are
properly adjusted.
CAUTION: Manual adjustment of Zoom and Focus is only
possible on the VX-2VA-B-IWD model version. Zoom and Focus controls can be configured digitally from
the camera’s web interface for VX-2VA-B-RIWD models. See the VISIX V-Series All-in-One Camera User
Manual for more details on adjusting lens settings from the camera’s web interface.
To Next Page
Loading...
Need help?
General
