3BHS799208 E01 REV E ACS5000 WATER-COOLED USER MANUAL 71/186
04 TRANSPORTATION, STORAGE AND DISPOSAL
4.7 Storage and handling of spare parts
4.7.1 Warranty information
IMPORTANT! Check the spare parts immediately after receipt for damages.
Report any damage to the shipping company and the ABB
service organization.
Observe the following to maintain spare parts in good condition and to
keep the warranty valid during the warranty period:
• Keep spare parts in their original packaging.
• Store printed circuit boards in antistatic bags or boxes.
• Storage temperature range: -5 °C – + 55 °C
• Storage place requirements:
- Free of vibration and shock.
- Protected against dust, sand, vermin and insects.
- Free of corrosive gases, salt or other impurities that could
damage electronic equipment.
- Dry, no condensation: relative air humidity: 5 – 95%
If in doubt whether the maximum allowed humidity is exceeded,
protect spare parts by an external heater.
• Do not touch a component without wearing a wrist grounding strap.
• Put the component on a grounded working surface protected
against electrostatic discharges.
• Hold the component only at the edge.
▲NOTICE
Risk of component damage.
Static electricity can damage printed circuit boards.
• Apply static-sensitive precautions when handling spare parts.
To Next Page
Loading...
Need help?
General
