AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B 211
Example: Entering and displaying the pump output
Configuring and using a value entry
The configuration and use of a value entry will be explained using the fol-
lowing example of entering and displaying the pump output.
The following Figure shows the function block configuration that results
from the configuration of the example. It consists of the function block 'FB
Const Pump' that is created when configuring the display element "Input
Pump", and the function block 'Pump' that is the system default.
I1
I2
‘FB
‘FB
Pumpe
Pumpe’
Konstante
Konst Pumpe’
Configuring value entry
1 Configure the display element for the pump output value entry. The
source is the function block 'FB Const Pump'.
2 Configure the display element for the bar display of the pump output.
The source is the function block 'FB Pump'.
To Next Page
Loading...
Need help?
General
