ABB AO2000 Series User Manual

348 AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B
Fidas24, Fidas24 NMHC: Operating specifications
The following data only applies if all the influence variables (e.g. flow, tem-
perature and air pressure) are constant. These apply for the measuring
ranges ≥ 50 mg org. C/m
3
; for smaller measuring ranges these only apply if
they set are at the factory per customer order.
Linearity deviation ≤ 2 % of the measurement span up to 5000 mg org. C/m
3
,
this value applies in a (calibrated) measuring range
Repeatability ≤ 0.5 % of the measuring range
Zero-point and sensitivity
drift
≤ 0.5 mg org. C/m
3
per week
Output fluctuation (2 σ)
≤ 0.5 % of span at electronic T90 time = 20 s, not smaller than 10 µg
org. C/m
3
Detection limit (4
σ)
≤ 1 % of span at electronic T90 time = 20 s, not smaller than 20 µg org. C/m
3
Oxygen dependence ≤ 2 % of measured value for 0 to 21 vol.% O
2
or ≤ 0.3 mg org. C/m
3
, whichever
is greater
Temperature influence Ambient temperature in permissible range:
on zero point and on sensitivity: ≤ 2 % per 10 °C in the measurement range
0 to 15 mg org. C/m
3
Power supply influence 24 V DC ± 5 %: ≤ 0.2 % of span or
230 V AC ± 10 %: ≤ of span
T
90
time Fidas24 T
90
< 1.5 s at a sample gas flow rate = 80 l/h and electronic T90 time = 1 s
T
90
time Fidas24 NMHC T
90
< 2.5 s via bypass, T
90
< 3 s via converter at sample gas flow = 80 l/h and
electronic T90 time = 1 s
Switch-over time
(Fidas24 NMHC)
between bypass and converter typically 20 s, depending on measurement
range

ABB AO2000 Series Specifications

General

Brand	ABB
Model	AO2000 Series
Category	Measuring Instruments
Language	English