Configuring the sensor head 37
Communication settings
The Communication settings tab allows you to set the RS-485 configuration, to define the TCP
configuration and to define 4–20 mA outputs. Accessing the Communication settings dialog box
requires the administrator password.
—
Figure 21 Communication settings dialog box
RS-485 Configuration
The RS-485 Configuration section allows you to change the protocol used (Modbus or DNP3). For
corresponding configuration parameters, see “Modbus table” on page C77 and “DNP3” on page D81.
The Modbus identification slave ID can be changed in this dialog box.
TCP Configuration
For the corresponding TCP configuration parameters, see “Modbus table” on page C77 and “DNP3” on
page D81.
4–20 mA Outputs Configuration
Use the 4–20 mA Outputs Configuration section to configure the minimum and maximum settings
for hydrogen and moisture. For more details on connecting the 4–20 mA output, see “Analog 4–20 mA
outputs” on page 25.
IEC 61850 Configuration
Displayed when Enable strict mode is checked. Only data objects in strict compliance to IEC 61850
edition 1 are available on the CoreSense IEC 61850 MMS Server.
When Enable strict mode is NOT checked, additional data objects are available.
To Next Page
Loading...
Need help?
General
