20 Start-up and operation
Starting and stopping the inverter
Inverter control with parameter
To enable inverter operation, set parameter 189.01 Inverter operation value to Enable. You
can edit the parameter value directly in the parameter group 189 Inverter Control with the
control panel or with a computer through USB or SCADA.
During the first start-up FIMER recommends that you limit the output using the parameter
130.75, let the inverter run for a few minutes at limited power, and check that no loud
noises or vibrations are present. Gradually increase the power output limit up to the
desired power.
To Next Page
Loading...
Need help?
General