Installing the module
WARNING!
Obey the safety instructions of the drive. If you ignore them,
injury or death, or damage to the equipment can occur.
If you are not a qualified electrical professional, do not do
installation or maintenance work.
1.
Stop the drive and do the steps in section Electrical safety
precautions (page 12) before you start the work.
2. Pull out the lock.
3. Put the module carefully into its position on the drive until the
retaining clips lock it into position.
4. Push in the lock.
5. Tighten the screw. The maximum tightening torque is 0.8 N·m
(7.1 lbf·in).
Note: The screw tightens the connections and grounds the
module. It is necessary for fulfilling the EMC requirements and
for correct operation of the module.
WARNING!
Tightening the screw too much can cause damage to the
threads.
See the applicable drive manual for further instructions on how to
install the module to the drive.
Do not install the FPTC-02 module on an FEA-03 F-series extension
adapter. The diagnostics of the module requires that you install it
directly on the drive control unit.
36 Mechanical installation
To Next Page
Loading...
Need help?
General
