- 4 -
000002FG
Warranty and supply conditions
The warranty conditions are considered to be valid if the Customer
adheres to the indications in this manual; any conditions deviating from
those described herein must be expressly agreed in the purchase order.
ABB declares that the equipment complies with the provisions of law currently in force in the
country of installation and has issued the corresponding declaration of conformity.
Not included in the supply
ABB accepts no liability for failure to comply with the instructions for correct installation and
will not be held responsible for systems upstream or downstream of the equipment it has
supplied.
It is absolutely forbidden to modify the equipment. Any modication, manipulation, or alteration
not expressly agreed with the manufacturer, concerning either hardware or software, shall
result in the immediate cancellation of the warranty.
The customer is fully responsible for any changes made to the system.
Given the countless array of system congurations and installation
environments possible, it is essential to check the following: adequate
spaces, suitable for housing the equipment; airborne noise produced
based on the environment; possible ammability conditions.
ABB will NOT be held liable for defects or malfunctions arising from:
improper use of the equipment; deterioration resulting from transportation
or particular environmental conditions; performing maintenance
incorrectly or not at all; tampering or unsafe repairs; use or installation by
unqualied persons.
ABB is not responsible for any loss of the equipment, or part of it, which
does not take place on the basis of the regulations and laws in force in
the country of installation.
1
Introduction and general information
To Next Page
Loading...
Need help?
General