Protection
Setting Ie 1
Setting Ie 2*
Trip class
Current factor
PTC
Cooling mode
Cooling time
Restart level %
Locked rotor (LR)
Thermal load warnlev
Phases
Over/under current
Voltage DIP**
Over/under voltage**
Voltage imbalance**
Load startup delay**
Over/under power**
Power factor**
Power quality**
*) Polechanging starter only
**) With voltage module only
Locked Rotor
LR trip level
LR trip delay
Phases
Phase loss protect.
Phase imb. trip lev.
Phase imb. warn lev.
Phase reversal
Check phase sequence
Over / under current
Low curr trip level
Low curr trip delay
Low curr warn level
Low curr warn delay
High curr trip level
High curr trip delay
High curr warn level
High curr warn delay
Earth flt. trip lev.
Earth flt. trip delay
Earth flt. warn lev.
Earth flt. warn delay
Earth fault detection
Voltage DIP
Enable voltage DIP
Voltage DIP duration
Autorestart enable
Autorestart window
Autorestart delay
DIP restart level
DIP level
Over / under voltage
U low trip level
U low trip delay
U low warn level
U low warn delay
U high trip level
U high trip delay
U high warn level
U high warn delay
Voltage imbalance
U imb trip level
U imb trip delay
U imb warn level
U imb warn delay
Over / under power
P low trip level
P low trip delay
P low warn level
P low warn delay
P high trip level
P high trip delay
P high warn level
P high warn delay
Power factor
PwrFactor trip level
PwrFactor trip delay
PwrFactor warn level
PwrFactor warn delay
Power quality
THD warn level
THD warn delay
Motor Protection Parameters
Within this submenu all motor protection related parameters can be configured.
The diagram below shows the organisation of the different parameter masks in the menu tree.
The parameters are described in detail in the section "Parameters and Data Structures on a Fieldbus->Parameter
Organisation-> Motor Protection Parameters".
105
To Next Page
Loading...
Need help?
General
