Check Current
Bypass signal DI0
(optinal)
Delay1
Delay2
YD-Time
Listed protection
functions disabled
Timing Diagram
• Opposite direction only possible after OFF and after the reverse lock-out time has elapsed.
• Restart in the same direction without consideration of the Reverse lock-out time.
Related parameters
• Reverse Lockout Time
• YD-Starting-Time (used as ramp-up time if no by-pass signal available)
• Delay 1 / Delay 2 (default value set, can be changed only in the custom application editor)
• Checkback delay time
• Checkback
—
Command Data for Softstarter
Word Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit1 Bit 0
- Fault Reset Auto Mode Prepare
Emergency
Start
- Run
Forward
Off Run Reverse
- - -
- - - -
Remaining data see section Parameters and Data Structures on a Fieldbus
1)
Controlled by the UMC100 if configured as fault output.
The table above represents the data allocation as realised with the built-in standard applications. It may differ for
customer-specific applications!
92
To Next Page
Loading...
Need help?
General
