ABB UMC100.3 User Manual

4
UMC100.3 UNIVERSAL MOTOR CONTROLLER MANUAL
65 Limit the Number of Starts
67 Using the Digital UMC Inputs
69 Single Phase and Three Phase Operation Mode
69 Stand-Still Supervision
69 Run-Time Supervision
70 Control Functions
72 Control Function Overload Relay
74 Control Function Direct Starter (DOL)
77 Control Function Reversing Starter (REV)
80 Control Function Star-Delta Starter
83 Control Function Pole-Changing Starter
86 Control Function Actuator 1 - 4
91 Control Function Softstarter
94 Controlling Resistive Loads
95 6 Configuring the Communication Interfaces
95 Setting the Bus Address
95 Specific Communication Settings for Modbus RTU and DeviceNet
96 Address Check when using UMC in Motor Control Centres
97 Defining the Bus Fault Reaction
97 Ignore Block Parameters
97 Change I/O data length on the fieldbus
98 Adjust cyclically transmitted Monitoring Words
98 Special considerations for backwards compatibility on DeviceNet and PROFINET
99 7 Using Expansion Modules
99 Using a Digital IO Module (DX111-FBP.0/122-FBP.0)
100 Using a Voltage Module (VI150-FBP.0/155-FBP.0)
100 Using an Analog Input Module (AI111.0)
101 8 The LCD Control Panel UMC100-PAN
101 Overview
102 Monitoring Status Information and menu tree
108 Adjusting Parameters
111 Starting and Stopping the Motor
113 9 Error handling, maintenance and service
113 Error handling of the UMC
113 UMC100.3 fault indication
113 Fault messages
118 Resetting parameters to factory defaults

ABB UMC100.3 Specifications

General

Brand	ABB
Model	UMC100.3
Category	Controller
Language	English