116
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator’s Manual Version 6
Applying a proficiency sample Once the meter has checked the test strip, the hourglass
icon disappears and you are prompted to apply the profi-
ciency sample.
1 Wait until the flashing drop appears in the display
before applying the sample. The meter beeps.
2 Apply a drop of sample to the front edge of the test
strip. Do not apply the sample to the top of the strip.
The sample is pulled into the test strip area by
capillary action.
Once sufficient sample has been detected, the meter
beeps and the measurement begins.
Profi ciency Test
Sample 123456789
Strip L
ot 545794
12:48 pm
03/17/17
When applying the proficiency sample, position the
meter so that the test strip port is always higher or on
the same level as the sample. This prevents any excess
sample from flowing down the strip and entering the
meter.
To Next Page
Loading...
Need help?
General
