13 Altos R720 Installation Configuration Guide
Software Required
The management utility of integrated SAS hardware RAID can be found in the
EasyBUILD.
Software Version EasyBUILD Version
RAID Web Console
2
2.63 EasyBUILD 8.0 build 200 (or later)
Intel PROSet Utility 13.0.44.0 EasyBUILD 8.0 build 200 (or later)
Configuring integrated SAS hardware RAID
Please refer to the Appendix A. for the integrated SAS hardware RAID
configuration.
Installation Tips
NOTE. The Windows Server 2008 can recognize integrated SAS hardware RAID.
Please replace the driver with the one provided by EasyBUILD. If you do not
have the optional internal USB floppy drive, you need an external USB floppy
drive or USB Flash drive to load driver during the OS installation.
1. Please make a driver diskette from the EasyBUILD first before the
installation.
2. Click on “Load Driver” when “Where do you want to install Windows”
message displayed.
3. Select “Intel(R) RAID Controller SROMBSAS18E (A:\oemsetup.inf)” as
target driver
4. After loading the RAID driver from diskette, you could click “Drive
options” to partition the drive.
5. Follow the normal procedure to finish the installation.
6. After the installation completes, you would see the following devices
with yellow mark in Device Manager.
To Next Page
Need help?
General
