35 Altos R720 Installation Configuration Guide
Windows 2000 Advanced Server SP4 Installation (with
integrated SAS hardware RAID)
Below information describes how to manually install Microsoft Windows 2000
Advanced Server SP4 on Altos R720 with integrated SAS hardware RAID.
Drivers Required
For Windows 2000 Installation, the following device drivers are required.
Device Version EasyBUILD Version
Integrated SAS
hardware RAID
1.17.0.32 EasyBUILD 7.1 build 100 (or later)
Onboard Chipset 7.3.0.1011 EasyBUILD 7.1 build 100 (or later)
Onboard Gigabit
Ethernet
9.3.39 EasyBUILD 7.1 build 100 (or later)
Onboard VGA 8.24.3 EasyBUILD 7.1 build 100 (or later)
Onboard USB 2.0 N/A OS built-in
IOAT 1.2.52.0 EasyBUILD 7.1 build 100 (or later)
Hot-swap
backplane
5.0.6055.2 EasyBUILD 7.1 build 100 (or later)
Software Required
The management utility of integrated SAS hardware RAID can be found in the
EasyBUILD 7.1 build 100 (or later).
Software Version EasyBUILD Version
RAID Web Console
2
1.13-00 EasyBUILD 7.1 build 100 (or later)
Intel PROSet Utility 10.4.4.2 EasyBUILD 7.1 build 100 (or later)
Configuring integrated SAS hardware RAID
Please refer to the Appendix A. for the integrated SAS hardware RAID
configuration.
Installation Tips
NOTE. There is no built-in driver Integrated SAS hardware RAID in the Windows
Server 2003. If you do not have the optional internal USB floppy drive, you
need an external USB floppy drive for applying driver during the OS installation.
1. As Windows 2000 can’t recognize the integrated SAS hardware RAID, you
need to make a driver diskette from the EasyBUILD 7.1 build 100 first
before the installation.
2. Press F6 at the start of installation to provide the driver disk for the
onboard ROMB.
3. Select “Intel(R) SAS RAID Controller Driver (Windows 2000)” as target
driver
To Next Page
Loading...
Need help?
General
