85 Altos R720 Installation Configuration Guide
Onboard Chipset N/A OS built-in
Onboard Gigabit
Ethernet
9.22 EasyBUILD 7.1 build 100 (or later)
Onboard VGA N/A OS built-in
Onboard USB 2.0 N/A OS built-in
Installation Tips
NOTE. You need to apply the integrated SAS hardware RAID and NIC driver
during the installation. If you do not have the optional internal USB floppy
drive, you need an external USB floppy drive.
1. Make a driver diskette for integrated SAS hardware RAID and onboard
Intel 82563EB Gigabit Ethernet from EasyBUILD 7.1 build 100.
2. Boot the system from the NetWare 6.5 SP5 OS CD.
3. At Welcome to the NetWare 6.5 server installation page, select Manual to
install.
4. At Prepare boot partition page, create one 500 MB DOS partition.
5. When you see the following message, please select Modify. Then, move
the cursor to Storage adapters and press Enter.
The following device drivers were detected for this
server. Add, change, or delete device drivers as
needed.
Device types Driver names
----------------------- --------------
Storage adapters: IDEATA, IDEATA, MEGA_SAS
6. Please press Delete to delete MEGA_SAS.HAM modules
7. Then, press INSERT key to insert the integrated SAS hardware RAID driver.
After the drivers are successfully loaded, please select Return to driver
summary.
8. Continue the installation.
9. When you see the following message, please select Modify. Then, move
the cursor to Network boards and press Enter.
The following device drivers were detected for this
server. Add, change, or delete device drivers as
needed.
Device types Driver names
------------------------- --------------
Network boards:
To Next Page
Loading...
Need help?
General
