31 Altos R720 Installation Configuration Guide
Drivers Required
For Windows Server 2003 Installation, the following device drivers are required.
Device Version EasyBUILD Version
Integrated SAS
hardware RAID 2
2.20.0.32 EasyBUILD 8.0 build 200 (or later)
Onboard Chipset 8.3.0.1011 EasyBUILD 8.0 build 200 (or later)
Onboard Gigabit
Ethernet
9.12.18.0 EasyBUILD 8.0 build 200 (or later)
Onboard VGA 8.24.3-
060405a-
038923C-Intel
EasyBUILD 8.0 build 200 (or later)
Onboard USB 2.0 N/A OS built-in
IOAT 1.2.79.9 EasyBUILD 8.0 build 200 (or later)
Hot-swap
backplane
5.0.6262.1 EasyBUILD 8.0 build 200 (or later)
Software Required
The management utility of integrated SAS hardware RAID 2 can be found in
the EasyBUILD 7.1 build 100 (or later).
Software Version EasyBUILD Version
Microsoft Scalable
Networking Pack
N/A
http://www.microsoft.com/downloads/
details.aspx?FamilyID=c65f4a89-f4da-
463e-a496-
4b5abd660bf9&DisplayLang=en
RAID Web Console
2
2.63 EasyBUILD 8.0 build 200 (or later)
Intel PROSet Utility 13.0.44.0 EasyBUILD 8.0 build 200 (or later)
Configuring integrated SAS hardware RAID 2
Please refer to the APPENDIX B. for the integrated SAS hardware RAID 2
configuration.
Installation Tips
NOTE. There is no built-in driver Integrated SAS hardware RAID 2 in the
Windows Server 2003. If you do not have the optional internal USB floppy drive,
you need an external USB floppy drive for applying driver during the OS
installation.
1. As Windows Server 2003 can’t recognize the integrated SAS hardware
RAID 2, you need to make a driver diskette from the EasyBUILD 7.1 build
100 first before the installation.
2. Press F6 at the start of installation to provide the driver disk for the
integrated SAS hardware RAID 2.
3. Select “Intel(R) SAS RAID Controller Driver (Server 2003 32-bit)” as target
To Next Page
Loading...
Need help?
General
