Error Messages
The following tables are abbreviated lists of function generator’s error
messages. They are intended to include errors which are likely to be
encountered during the procedures described in this chapter. For a more
complete list of error messages and descriptions, see chapter 5 in the
Agilent 33120A User’s Guide.
System Error Messages
Error Error Message
-330 Self-test Failed
-350 Too many errors
501 Isolator UART framing error
502 Isolator UART overrun error
511 RS-232 framing error
512 RS-232 overrun error
513 RS-232 parity error
514 Command allowed only with RS-232
521 Input buffer overflow
522 Output buffer overflow
550 Command not allowed in Local
Self-Test Error Messages
Error Error Message
601 Front panel does not respond
602 RAM read/write fail
603 Waveform RAM readback failed
604 Modulation RAM readback failed
605 Serial configuration readback failed
606 Waveform ASIC failed
607 SYNC signal detection failure
608 SYNC signal detection failure
625 I/O Processor not responding
626 I/O Processor failed self-test
627 I/O Processor reset; possible low power line voltage
4
Chapter 4 Calibration Procedures
Error Messages
81
To Next Page
Loading...
Need help?
General
