4-34
MegaZoom Concepts and Oscilloscope Operation
To display and rearrange the digital channels
To display and rearrange the digital channels
1Press the D15 Thru D8 key or D7 Thru D0 key to turn the display of the digital
channels on or off.
Digital channels are displayed when the D15 Thru D8 or D7 Thru D0 key is
illuminated.
2 Turn the Digital Channel Select knob to select a digital channel.
As you turn the Channel Select knob, the selected channel number is
highlighted on the left side of the display.
3 Turn the Digital position knob to reposition the selected channel on the
display.
If two or more channels are displayed at the same vertical position, the channel
number will be shown as D* on the left side of the display. When you use the
Channel Select knob to select this channel, a pop up will appear showing the
list of overlaid channels. Continue turning the Channel Select knob until the
desired channel within the pop up is selected. You can also use this feature to
bus several signals together on the display.
List of stacked
channels
To Next Page
Loading...
Need help?
General
